Pro­ducts for your needs

028 Portraet scaled
IPS-20
Inter­ac­ti­ve test­ing and simu­la­ti­on system

The inter­ac­ti­ve test­ing and simu­la­ti­on sys­tem (IPS) brings tog­e­ther test­ing and modelling.

Appro­pria­te use of the IEC 61850–6‑compliant data­ba­se pro­vi­des the neces­sa­ry infor­ma­ti­on to adapt the test sys­tem to dif­fe­rent test tasks.

The inter­face bet­ween the pri­ma­ry and secon­da­ry sys­tem tech­no­lo­gy is usual­ly imple­men­ted in par­al­lel with cop­per. Your effec­ti­ve and relia­ble test­ing requi­res a powerful tool — the IPS-20.

With the IPS-20, the deman­ding elec­tri­cal signals of the sta­ti­on con­trol tech­no­lo­gy can be obser­ved and simulated.


Systemtechnik - WASIM 20
WASIM-20
con­ver­ter simulation

The con­ver­ter simu­la­ti­on WASIM-20 enables the three-pha­se sta­tus simu­la­ti­on of vol­ta­ge and cur­rent converters.

A relia­ble check of the con­trol tech­no­lo­gy func­tions, mea­su­red value acqui­si­ti­on and mea­su­red value pro­ces­sing in ener­gy sup­p­ly sys­tems is her­eby effi­ci­ent­ly possible.

For the simu­la­ti­on of vol­ta­ge and cur­rent values ​​at the pro­cess inter­face to the con­trol sys­tem, the WASIM-20 can be used to mea­su­re curr­ents in the ran­ge from 0 to 5.5A and vol­ta­ges bet­ween 0 and 65V, as well as the pha­se ang­le bet­ween cur­rent and vol­ta­ge from ‑180° to +180° be specified.



Mon01
Cell vol­ta­ge moni­to­ring in elec­tro­ly­sis systems

For the pro­duc­tion of pla­s­tics, chlo­ri­ne gas and hydro­gen gas are gene­ra­ted in indus­tri­al elec­tro­ly­sis pro­ces­ses. The indi­vi­du­al cells of the elec­tro­ly­ser are ope­ra­ted with low vol­ta­ges (approx. 2 V) and very high curr­ents (approx. 5000 A). In order to avo­id major eco­no­mic dama­ge, the ear­ly detec­tion of cell defects is abso­lut­e­ly neces­sa­ry. In rela­ti­on to the cur­rent cur­rent value, a signi­fi­cant chan­ge in the cell vol­ta­ge to hig­her or lower ope­ra­ting values ​​is rele­vant for error detec­tion. H&S has deve­lo­ped a ful­ly elec­tro­nic solu­ti­on for this moni­to­ring task and imple­men­ted it in pro­duc­tion plants. In addi­ti­on to the relia­ble detec­tion of an impen­ding mal­func­tion, the defec­ti­ve cell can also be pre­cis­e­ly located.

Uniplex II
deve­lo­p­ment of an elec­tro­nic con­trol­ler for the petro­che­mi­cal industry

The customer’s request was the deve­lo­p­ment of an indus­tri­al, com­pact con­trol­ler and safe­ty tem­pe­ra­tu­re limi­ter for the ope­ra­ti­on of lar­ge, dis­tri­bu­ted, decen­tra­li­zed hea­ting cir­cuits. A sys­te­ma­tic requi­re­ments ana­ly­sis pro­vi­ded the basis for the con­cep­ti­on and deve­lo­p­ment by the H&S team. Through the use of modern sen­sor and micro­con­trol­ler tech­no­lo­gy as well as stan­dar­di­zed real-time capa­ble com­mu­ni­ca­ti­on tech­no­lo­gy such as Ether­net and Pro­fi­bus, a sys­tem was crea­ted that works relia­bly in lar­ge num­bers in an indus­tri­al envi­ron­ment. In addi­ti­on to the con­trol and moni­to­ring func­tions, the instal­led soft­ware enables easy on-site ope­ra­ti­on and inte­gra­ti­on into a pro­cess con­trol sys­tem. The pre­scri­bed docu­ments and tests for cer­ti­fi­ca­ti­on accor­ding to ATEX and NAMUR were pro­per­ly pre­pared by H&S and the accep­tance pro­ce­du­res were pro­fes­sio­nal­ly accom­pa­nied by a com­mis­sio­ned test­ing institute.

Cont­act

Our pro­ject deve­lo­pers for the area of ​​hard­ware deve­lo­p­ment are at your dis­po­sal for ques­ti­ons and advice